ADI:Solving Dynamic Range Problems in Analog Systems
A look at the dual challenges of providing the highest sensitivity amplifiers possible and making them operable under severe overload conditions.
2020-04-26 15:19:02A look at the dual challenges of providing the highest sensitivity amplifiers possible and making them operable under severe overload conditions.
2020-04-26 15:19:02This next study will show some results comparing the relative effects of mismatches and noise.
2020-04-26 15:19:02A look at the data conversion block in wireless infrastructure designs, and selecting a converter that is targeted for this application.
2020-04-26 15:18:59三轴加速度传感器在跌倒检测中的应用
2020-04-26 15:18:47In order to make the best use of the increased resolution, effective and rapid autofocus (AF) must accompany the increase in pixels.
2020-04-26 15:18:46A look at overcoming design barriers with new converter architectures.
2020-04-26 15:18:40While amplitude response is generally of greater interest than phase response, sometimes the phase response of the filter is important.
2020-04-26 15:18:28A discussion about using components with lower intermodulation distortion and lower noise in modern digital radio transmitter design.
2020-04-26 15:18:26A look at two advances in digital isolation technology that are yielding new capabilities to greatly simplify designers’ jobs.
2020-04-26 15:18:23The vastly complex arena of analog design
2020-04-26 15:18:19A look at an alternative method to measure junction temperature using an on-chip output stage protection diode as a temperature sensor.
2020-04-26 15:18:19Some thoughts on characterizing network frequency response rapidly, with minimal effort and available tools.
2020-04-26 15:17:55A look at the challenges found with single-supply op-amp applications.
2020-04-26 15:17:49A look at the challenges such as of thick molding compounds, noisy environments, reliability concerns, and long interconnect distances from sensor to IC.
2020-04-26 15:17:45Using a touch to change to activate a switch is well understood, but making a PCB sensor design with proper shielding and routing can be a challenge.
2020-04-26 15:17:44A discussion about improving battery life through enhancing the efficiency of the power system.
2020-04-26 15:17:19How to measure the temperature of the PCB.
2020-04-26 15:17:13A look at hot swapping: the process of removing and replacing a board or module while the system remains up and running.
2020-04-26 15:17:13A discussion of how high-speed amplifiers can be less expensive than traditional clock buffers in consumer electronic applications.
2020-04-26 15:17:06A discussion about the need to compensate for errors from the DAC and other components in the signal chain in order to get an accurate output voltage.
2020-04-26 15:17:03